PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Axle System Symptom | Suspected Area | Link |
---|---|---|
Wander or pulls | Tires (worn or improperly inflated) | |
Front wheel alignment (incorrect) | | |
Rear wheel alignment (incorrect) | | |
Steering intermediate shaft (loose or worn) | | |
Front axle hub bearings (loose or worn) | | |
Rear axle hub bearings (loose or worn) | | |
Steering gear (broken) | | |
Suspension parts (worn out) | - | |
Front wheel shimmy | Tires (worn or improperly inflated) | |
Wheels (out of balance) | | |
Front shock absorber (worn out) | | |
Front wheel alignment (incorrect) | | |
Lower ball joint (worn) | | |
Front axle hub bearings (loose or worn) | | |
Steering intermediate shaft (loose or worn) | | |
Steering gear (broken) | | |
Rear wheel shimmy | Tires (worn or improperly inflated) | |
Wheels (out of balance) | | |
Rear shock absorber (worn out) | | |
Rear axle hub bearings (loose or worn) | | |
Rear wheel alignment (incorrect) | |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Theft Deterrent / Keyless Entry: Id Code Box
ComponentsCOMPONENTS ILLUSTRATION *1 AIR CONDITIONER UNIT ASSEMBLY *2 ID CODE BOX (IMMOBILISER CODE ECU) InstallationINSTALLATION CAUTION / NOTICE / HINT NOTICE: Before replacing the ID code box (immobiliser code ECU), refer to Registration. Click here PROCEDURE 1. INSTALL ID CODE B ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Power Tilt And Power Telescopic Steering Column System: Tilt and Telescopic Manual Switch Circuit
DESCRIPTION Different voltage values are sent to the multiplex tilt and telescopic ECU by operating the tilt and telescopic switch. The multiplex tilt and telescopic ECU then judges which motor and in which direction that motor should operate based on the voltage value. WIRING DIAGRAM PROCEDURE ...