COMPONENTS
ILLUSTRATION
*1 | FRONT WHEEL OPENING EXTENSION PAD LH | *2 | NO. 3 ENGINE UNDER COVER |
*3 | FRONT FENDER APRON SEAL LH | - | - |
ILLUSTRATION
*1 | REFILL PLUG | *2 | DRAIN PLUG |
*3 | OVERFLOW PLUG | *4 | GASKET |
*5 | O-RING | - | - |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
ILLUSTRATION
*1 | TRANSFER CASE OIL SEAL RH | *2 | FILLER PLUG (NO. 1 TRANSFER CASE PLUG) |
*3 | TRANSFER DRAIN PLUG | *4 | GASKET |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part | |
MP grease | - | - |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Ultrasonic Sensor (for Front): Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT CENTER ULTRASONIC SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 4 (BI) - 6 (EI) Always 10 kΩ or higher 4 (BI) - 1 (BO) Always Below ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Steering Angle Sensor: Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: A lock pin is installed to a new steering sensor. Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly. PROCEDURE 1. INSPECT SPIRAL CABLE SUB-ASSEMBLY Click here 2. INSTALL STEERING SENSOR (a) Align the ...