Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Inspection

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual / Engine & Hybrid System / 2gr-fks (fuel) / Fuel Pressure Sensor / Inspection

INSPECTION

PROCEDURE

1. INSPECT FUEL DELIVERY PIPE SUB-ASSEMBLY (FUEL PRESSURE SENSOR)

NOTICE:

  • Do not remove the fuel pressure sensor from the fuel delivery pipe sub-assembly.
  • If the fuel pressure sensor is removed, replace the fuel delivery pipe sub-assembly (fuel pressure sensor) with a new one.

(a) Check the fuel pressure sensor output voltage.

(1) Apply 5 V between terminals 1 (VC) and 3 (E2).

NOTICE:

  • Be careful when connecting the leads, as the fuel pressure sensor may be damaged if the leads are connected to the wrong terminals.
  • Do not apply more than 6 V to terminals 1 (VC) or 3 (E2).

HINT:

If a stable power supply is not available, connect 4 nickel-metal hydride batteries (1.2 V each) or equivalent in series.

*a

Component without harness connected

(Fuel Pressure Sensor)

*b

Voltage Applied between Terminals

(2) Measure the voltage between terminals.

Standard Voltage:

Tester Connection

Condition

Specified Condition

2 (PFL) - 3 (E2)

Pressure not applied to fuel pressure sensor

Approximately 0.56 to 0.94 V*

*: The output voltage changes depending on the voltage applied to the terminals.

If the result is not as specified, replace the fuel delivery pipe sub-assembly (fuel pressure sensor).

*a

Component without harness connected

(Fuel Pressure Sensor)
    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY (FUEL PRESSURE SENSOR) HINT: Perform "Inspection After Repair" after replacing the fuel delivery pipe sub-assembly (fuel pressure sens ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Back Door Lock: Installation
    INSTALLATION PROCEDURE 1. INSTALL BACK DOOR LOCK ASSEMBLY HINT: Make sure to remove the string before installing a new back door lock assembly. (a) Apply MP grease to the sliding parts of the back door lock assembly. (b) Engage the clip to temporarily install the back door lock assembly as shown in ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sliding Roof System: Data List / Active Test
    DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be dis ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.0106