ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK STEERING EFFORT (TORQUE)
NOTICE:
These service operations may affect the SRS airbags. Be sure to read the precautionary notices concerning the SRS airbag system before servicing.
Click here
(a) Stop the vehicle on a level, paved surface and align the wheels straight ahead.
(b) Remove the horn button assembly.
Click here
(c) Connect the cable to the negative (-) battery terminal.
(d) Using a torque wrench, check that the steering wheel assembly set nut is properly tightened.
Torque:
50 N·m {510 kgf·cm, 37 ft·lbf}
(e) Start the engine so that the power steering is ready to operate.
(f) Turn the steering wheel 90 degrees to the right and check steering effort (torque) with the steering wheel turned. Check in the opposite direction using the same method.
Standard Steering Effort (Reference):
6.9 N*m (70 kgf*cm, 61 in.*lbf) or less
(g) Align the front wheels facing straight ahead.
(h) Turn the engine switch off.
(i) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
(j) Install the horn button assembly.
Click here
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Vacuum Pump: On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY Click here 2. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY Click here 3. OPERATION CHECK (a) Slide the clip and disconnect the air tube from the vacuum pump assembly. (b) Connect the hose of the vacuum gauge to the va ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Automatic Transaxle Assembly: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during automatic transaxle assembly removal/installation are shown below. Necessary Procedure After Parts Remov ...