DIAGNOSTIC TROUBLE CODE CHART
Power Tilt and Power Telescopic Steering Column System DTC No. | Detection Item | DTC Detection Condition | Link |
---|---|---|---|
B2603 | Tilt and Telescopic Manual Switch Circuit Malfunction | When operating the tilt and telescopic switch, an abnormal voltage value is sent to the multiplex tilt and telescopic ECU. |
|
B2610 | Tilt Position Sensor or Tilt Motor Circuit Malfunction | Tilt operation stops within the operation range while operating. |
|
B2611 | Telescopic Position Sensor or Telescopic Motor Circuit Malfunction | Telescopic operation stops within the operation range while operating. |
|
B2620 | ECU Power Source Circuit Malfunction | The voltage of the ECU power source drops to 8 V or less and this condition continues for 10 seconds or more. |
|
B2624 | Vehicles Speed Malfunction |
|
|
U0142 | Lost Communication with Main Body ECU | Lost communication with main body ECU (multiplex network body ECU) |
|
U0208 | Lost Communication with "Seat Control Module A" | Lost communication with position control ECU and switch assembly LH |
|
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Occupant Classification System: Dtc Check / Clear
DTC CHECK / CLEAR DTC CHECK (a) Turn the engine switch off. (b) Connect the Techstream to the DLC3. (c) Turn the engine switch on (IG), and wait for at least 10 seconds. (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / Occupant Detection / Trouble Codes. Body Electrical & ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Solar Sensor: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during solar sensor removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Rep ...