INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL HOOD STAY BRACKET
(a) Engage the guide.
(b) Install the hood stay bracket with the bolt.
Torque:
17.5 N·m {178 kgf·cm, 13 ft·lbf}
2. INSTALL HOOD SUPPORT BRACKET
(a) Engage the guide.
(b) Install the hood support bracket with the bolt.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
3. INSTALL HOOD SUPPORT ASSEMBLY
NOTICE:
(a) Engage the 2 ball joints to install the hood support assembly. NOTICE: Install the hood support assembly while supporting the hood by hand. | |
(b) Check that the ball joints are engaged securely and the hood support assembly cannot be pulled off.
4. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY
Click here
5. INSTALL FRONT WIPER MOTOR AND LINK ASSEMBLY
Click here
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Meter / Gauge System: On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT COMBINATION METER ASSEMBLY (a) Check speedometer operation NOTICE:
The combination meter assembly receives the vehicle speed signal from the brake actuator assembly (skid control ECU) via CAN communication. Therefore, perform the following inspection ref ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Vehicle Stability Control System: ABS Solenoid Control Module Actuator Stuck On (C143A7E,C143A7F)
DESCRIPTION The ABS solenoid relay is built into the skid control ECU in the brake actuator assembly. The ABS solenoid relay supplies power to the holding solenoid and reduction solenoid. The solenoid relay is turned on 1.5 seconds after the engine switch is turned on (IG), and is turned off if an o ...