PRECAUTION
PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
System Name | See Procedure |
---|---|
Lane Control System |
|
Pre-collision System | |
Intelligent Clearance Sonar System | |
Parking Assist Monitor System | |
Panoramic View Monitor System | |
Lighting System (w/ Automatic Headlight Beam Level Control System) | |
Power Door Lock Control System | |
Power Back Door System (w/ Outside Door Control Switch) |
PRECAUTION FOR BULB REPLACEMENT
(a) Always prepare a new bulb for immediate replacement. While replacing the bulb, the lens may attract dust and moisture if the bulb is removed from the vehicle for a long time.
(b) Always replace a bulb with another bulb of the same wattage.
(c) If only replacing the bulb on one side, differences in brightness and lighting color between the right and left sides may occur.
(d) Securely install the socket after bulb replacement. The lens may become cloudy or the light assembly may fill with water through gaps around the socket if it is not installed securely.
PRECAUTION FOR AUTOMATIC HIGH BEAM SYSTEM (w/ Automatic High Beam System)
(a) General Description
The automatic high beam system is a system that helps ensure visibility by automatically turning the high beam headlights on and off. Additionally, due to control limitations of the automatic high beam system, it may be necessary to manually turn the high beam headlights on and off. For safety reasons, make sure to turn the high beam headlights on and off manually according to the driving conditions.
(b) Conditions Unsuitable for Using Automatic High Beam System
Under the following conditions, the automatic high beam system might not detect other vehicles or lights correctly, or the high beam headlights might cause glare or flash pedestrians or the occupants of other vehicles. Manual operation should be considered.
Factor | Condition |
---|---|
Weather/Climate |
|
Front windshield | Refer to Front Camera System.
|
Forward recognition camera | Refer to Front Camera System.
|
Nearby vehicles or lights |
|
Road conditions |
|
Own vehicle |
|
Automatic high beam system | Malfunction: When the automatic high beam indicator light on the combination meter assembly is off and "Headlight System Malfunction Visit Your Dealer" is displayed on the multi-information display. Others:
|
PRECAUTION FOR FRONT CAMERA SYSTEM (w/ Automatic High Beam System)
Click here
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Can Communication System: Check Bus 5 Lines for Short Circuit
DESCRIPTION There may be a short circuit between the bus 5 main lines and/or bus 5 branch lines when the resistance between terminals 15 (CA5H) and 16 (CA5L) of the network gateway ECU is below 54 Ω. Symptom Trouble Area Resistance between terminals 15 (CA5H) and 16 (CA5L) of network gatew ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Transfer Case Front Oil Seal (for Rh Side): Components
COMPONENTS ILLUSTRATION *1 FRONT WHEEL OPENING EXTENSION PAD LH *2 NO. 3 ENGINE UNDER COVER *3 FRONT FENDER APRON SEAL LH - - ILLUSTRATION *1 REFILL PLUG *2 DRAIN PLUG *3 OVERFLOW PLUG *4 GASKET *5 O-RING - - Tightening torque for "Major ar ...