INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL REAR LIGHT ASSEMBLY (for Bulb Type Turn Signal Light)
(a) Engage the pin to temporarily install the rear light assembly as shown in the illustration.
Install in this Direction |
(b) Install the rear light assembly with the 3 nuts. Torque: 7.0 N·m {71 kgf·cm, 62 in·lbf} | |
(c) Connect the connector.
2. INSTALL REAR LIGHT ASSEMBLY (for LED Type Turn Signal Light)
(a) Engage the pin to temporarily install the rear light assembly as shown in the illustration.
Install in this Direction |
(b) Install the rear light assembly with the 3 nuts. Torque: 7.0 N·m {71 kgf·cm, 62 in·lbf} | |
(c) Connect the connector.
3. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
Click here
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Exterior Panels / Trim: Wheel Opening Moulding(for Rear Side)
ComponentsCOMPONENTS ILLUSTRATION *1 QUARTER OUTSIDE MOULDING SUB-ASSEMBLY - - ● Non-reusable part - - RemovalREMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE QUA ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Rear Seatback Heater (for 60/40 Split Seat Type Rh Side): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seatback heater removal/installation are shown below. Necessary Procedure After Parts Removed/Insta ...