DESCRIPTION
When the engine switch is on (IG), the power window regulator motor assembly (for rear RH door) is operated by the rear power window regulator switch assembly (for RH door). The power window regulator motor assembly (for rear RH door) has motor, regulator, and ECU functions.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Click here
Click here
Click here
PROCEDURE
1. | READ VALUE USING TECHSTREAM (MAIN BODY) |
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Data List.
(e) Read the Data List according to the display on the Techstream.
Body Electrical > Main Body > Data List Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
---|---|---|---|---|
Communication RR-Door Motor | Connection status between power window regulator motor assembly (for rear RH door) and main body ECU (multiplex network body ECU) | STOP or OK | STOP: Communication stopped OK: Normal communication | - |
Tester Display |
---|
Communication RR-Door Motor |
OK:
OK is displayed for each Data List item above.
NG | GO TO LIN COMMUNICATION SYSTEM (Proceed to How to Proceed with Troubleshooting) |
|
2. | READ VALUE USING TECHSTREAM (RR-DOOR MOTOR) |
(a) Enter the following menus: Body Electrical / RR-Door Motor / Data List.
(b) Read the Data List according to the display on the Techstream.
Body Electrical > RR-Door Motor > Data List Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
---|---|---|---|---|
RR Door P/W Up SW | Rear RH door power window manual up switch signal | OFF or ON | OFF: Rear RH door power window manual up switch not being operated ON: Rear RH door power window manual up switch being operated | - |
RR Door P/W Down SW | Rear RH door power window manual down switch signal | OFF or ON | OFF: Rear RH door power window manual down switch not being operated ON: Rear RH door power window manual down switch being operated | - |
Tester Display |
---|
RR Door P/W Up SW |
RR Door P/W Down SW |
OK:
On the Techstream screen, ON or OFF is displayed accordingly.
NG | GO TO STEP 4 |
|
3. | PERFORM ACTIVE TEST USING TECHSTREAM (RR-DOOR MOTOR) |
(a) Enter the following menus: Body Electrical / RR-Door Motor / Active Test.
(b) Perform the Active Test according to the display on the Techstream.
CAUTION:
Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function will not operate.
Body Electrical > RR-Door Motor > Active Test Tester Display | Measurement Item | Control Range | Diagnostic Note |
---|---|---|---|
Power Window | Power window | OFF / DOWN / UP | - |
Tester Display |
---|
Power Window |
OK:
Rear RH door power window operates normally.
OK | REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
NG | REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR RH DOOR) |
4. | INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR RH DOOR) |
(a) Remove the rear power window regulator switch assembly (for RH door).
Click here
(b) Inspect the rear power window regulator switch assembly (for RH door).
Click here
NG | REPLACE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR RH DOOR) |
|
5. | CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH (FOR RH DOOR) - POWER WINDOW REGULATOR MOTOR (FOR REAR RH DOOR) AND BODY GROUND) |
(a) Disconnect the O1 power window regulator motor assembly (for rear RH door) connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance Tester Connection | Condition | Specified Condition |
---|---|---|
Q1-2 (UP) - O1-10 (UP1) | Always | Below 1 Ω |
Q1-2 (UP) or O1-10 (UP1) - Body ground | Always | 10 kΩ or higher |
Q1-10 (DOWN) - O1-7 (DWN1) | Always | Below 1 Ω |
Q1-10 (DOWN) or O1-7 (DWN1) - Body ground | Always | 10 kΩ or higher |
Q1-5 (GND) - Body ground | Always | Below 1 Ω |
OK | REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR RH DOOR) |
NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Meter / Gauge System: Fuel Receiver Gauge Display Malfunction
DESCRIPTION FUEL RECEIVER GAUGE OPERATION (a) OPERATION The combination meter assembly uses the fuel sender gauge assembly to detect the amount of fuel remaining in the fuel tank assembly. The Hall IC built into the fuel sender gauge assembly changes the output voltage according to the amount of fue ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Transfer System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected ...