CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. | VEHICLE BROUGHT TO WORKSHOP |
|
2. | CUSTOMER PROBLEM ANALYSIS |
HINT:
What | Vehicle model, system name |
When | Date, time, occurrence frequency |
Where | Road conditions |
Under what conditions? | Driving conditions, weather conditions |
How did it happen? | Problem symptoms |
|
3. | PRE-CHECK |
(a) Measure the battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
(b) Check the fuses and relays.
(c) Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.
|
4. | CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
(a) Using the Techstream, check for CAN communication system DTCs.
Click here
Result | Proceed to |
---|---|
CAN DTCs are not output | A |
CAN DTCs are output | B |
B | GO TO CAN COMMUNICATION SYSTEM |
|
5. | PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table.
Click here
Result | Proceed to |
---|---|
Fault is not listed in Problem Symptoms Table. | A |
Fault is listed in Problem Symptoms Table. | B |
B | GO TO STEP 7 |
|
6. | OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Operation Check
Click here
(b) Terminals of ECU
Click here
(c) Data List / Active Test
Click here
(d) On-vehicle Inspection
Click here
|
7. | REPAIR OR REPLACE |
|
8. | CONFIRMATION TEST |
NEXT | END |
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Audio And Visual System (for 8 Inch Display): Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
DESCRIPTION The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio receiver assembly via this circuit. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) (a) Disconnect the J148 ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Vehicle Stability Control System: Fail-safe Chart
FAIL-SAFE CHART FAIL-SAFE OPERATION
If there is a problem with sensor signals or actuator systems, the skid control ECU prohibits power supply to the brake actuator assembly and informs the ECM of a VSC system malfunction.
The brake actuator assembly turns off the solenoids and the ECM stops its ...