INSPECTION
PROCEDURE
1. INSPECT FRONT DOOR LOCK WITH MOTOR ASSEMBLY LH
(a) Check the operation of the door lock motor. (1) Apply battery voltage and check the operation of the door lock motor. OK:
If the result is not as specified, replace the front door lock with motor assembly LH. |
|
(b) Check the operation of the door unlock detection switch.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
---|---|---|
7 (E) - 8 (LSSR) | Locked | 10 kΩ or higher |
7 (E) - 8 (LSSR) | Unlocked | Below 1 Ω |
If the result is not as specified, replace the front door lock with motor assembly LH.
(c) Check the operation of the door key lock and unlock switch. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the front door lock with motor assembly LH. |
|
2. INSTALL FRONT DOOR LOCK WITH MOTOR ASSEMBLY RH
(a) Check the operation of the door lock motor. (1) Apply battery voltage and check the operation of the door lock motor. OK:
If the result is not as specified, replace the front door lock with motor assembly RH. |
|
(b) Check the operation of the door unlock detection switch.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
---|---|---|
7 (LSSR) - 8 (E) | Locked | 10 kΩ or higher |
7 (LSSR) - 8 (E) | Unlocked | Below 1 Ω |
If the result is not as specified, replace the front door lock with motor assembly RH.
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Washer Level Warning Switch: Inspection
INSPECTION PROCEDURE 1. INSPECT LEVEL WARNING SWITCH ASSEMBLY HINT: This check should be performed with the level warning switch assembly installed on the washer jar. (a) Fill the washer jar with washer fluid. *a Component without harness connected (Level Warning Switch Assembly) ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Cylinder Head: Replacement
REPLACEMENT CAUTION / NOTICE / HINT HINT:
Use the same procedure for bank 1 and bank 2.
The following procedure is for bank 2.
PROCEDURE 1. REPLACE INTAKE VALVE GUIDE BUSH (a) Heat the cylinder head LH to between 80 and 100°C (176 and 212°F). (b) Place the cylinder head LH on wooden blocks ...