CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. | VEHICLE BROUGHT TO WORKSHOP |
|
2. | CUSTOMER PROBLEM ANALYSIS CHECK |
HINT:
What | Vehicle model, system name |
When | Date, time, occurrence frequency, whether the problem occurred recently or has been occurring for a long time |
Where | Whether the problem occurs at a specific location |
Under what conditions? | Whether the doors were locked or unlocked, whether the engine switch was on, whether the engine has started |
How did it happen? | Problem symptoms |
|
3. | PRE-CHECK |
(a) Measure the battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
(b) Check the fuses and relays.
(c) Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.
|
4. | CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
(a) Using the Techstream, check for CAN communication system DTCs.
Click here
Result | Proceed to |
---|---|
CAN DTCs are not output | A |
CAN DTCs are output | B |
B | GO TO CAN COMMUNICATION SYSTEM |
|
5. | CHECK FOR DTC (WIRELESS DOOR LOCK CONTROL SYSTEM)* |
(a) Clear the DTCs.
Click here
Body Electrical > Smart Access > Clear DTCs(b) Recheck for DTCs.
Body Electrical > Smart Access > Trouble Codes Result | Proceed to |
---|---|
DTCs are not output | A |
DTCs are output | B |
B | GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
6. | PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table.
Click here
Result | Proceed to |
---|---|
Fault is not listed in Problem Symptoms Table | A |
Fault is listed in Problem Symptoms Table | B |
B | GO TO STEP 8 |
|
7. | OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Terminals of ECU
Click here
(b) Data List / Active Test
Click here
(c) Operation Check
Click here
(d) Inspection
|
8. | REPAIR OR REPLACE |
|
9. | CONFIRMATION TEST |
NEXT | END |
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Blind Spot Monitor System: Master Module Horizontal Axis Misalignment (C1AC1)
DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor LH deviates more than the allowable range from the horizontal axis. HINT:
If a drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor s ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Panoramic View Monitor System: Side Camera Current Malfunction (C1684)
DESCRIPTION This DTC is stored if the parking assist ECU judges as a result of its self check that a synchronization problem is occurring in the image signal sent from the passenger side television camera assembly to the parking assist ECU. DTC No. Detection Item DTC Detection Condition Tro ...