CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
PROCEDURE
1. | CHECK CD |
(a) Check that the CD is not deformed or cracked. OK: CD is not cracked or deformed. | |
NG | END (CD IS FAULTY) |
|
2. | CHECK CD |
(a) Check the CD. OK: The CD is clean. NOTICE: Do not use a conventional record cleaner or anti-static preservative. HINT: If dirt is on the CD surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction. | |
NG | CLEAN CD |
|
3. | REPLACE CD AND RECHECK |
(a) Replace the CD with a new or known good one and check that the malfunction disappears.
OK:
Malfunction disappears.
OK | END (CD WAS FAULTY) |
|
4. | CHECK RADIO RECEIVER ASSEMBLY |
(a) Check the radio receiver assembly installation condition.
(1) Check that the radio receiver assembly is properly installed.
OK:
The radio receiver assembly is properly installed.
OK | REPLACE RADIO RECEIVER ASSEMBLY |
NG | REINSTALL RADIO RECEIVER ASSEMBLY |
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Roof Drip Side Finish Moulding: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP NOTICE: When installing new roof drip side finish moulding clips, remove any double-sided tape r ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > 4wd Control Ecu: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during 4WD ECU assembly removal/installation are shown below. Necessary Procedures After Parts Removed/Installe ...