INSPECTION
PROCEDURE
1. INSPECT NO. 1 COOLER THERMISTOR
(a) Measure the resistance according to the value(s) in the table below.
*a | Component without harness connected (No. 1 Cooler Thermistor) | *b | Sensing Portion |
*c | Resistance (kΩ) | *d | Temperature (°C (°F)) |
*e | Allowable Range | - | - |
Standard Resistance:
Tester Connection | Condition | Specified Condition |
---|---|---|
1 - 2 | -10°C (14°F) | 7.30 to 9.10 kΩ |
-5°C (23°F) | 5.65 to 6.95 kΩ | |
0°C (32°F) | 4.40 to 5.35 kΩ | |
5°C (41°F) | 3.40 to 4.15 kΩ | |
10°C (50°F) | 2.70 to 3.25 kΩ | |
15°C (59°F) | 2.14 to 2.58 kΩ | |
20°C (68°F) | 1.71 to 2.05 kΩ | |
25°C (77°F) | 1.38 to 1.64 kΩ | |
30°C (86°F) | 1.11 to 1.32 kΩ |
If the resistance is not as specified, replace the No. 1 cooler thermistor.
NOTICE:
HINT:
As the temperature increases, the resistance decreases (see the graph).
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Rear Combination Light Assembly (w/ Rear No. 2 Seat): Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE REAR COMBINATION LIGHT CAP (for LED Type Turn Signal Light) (a) for TMMC Made: (1) Remove the rear combination light cap. HINT: Use ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Fuel Tank: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pump removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Repla ...