REMOVAL
PROCEDURE
1. REMOVE REAR COOLING UNIT ASSEMBLY
Click here
2. REMOVE REAR NO. 2 COOLING UNIT DAMPER SERVO SUB-ASSEMBLY
Click here
3. REMOVE REAR NO. 1 COOLING UNIT DAMPER SERVO SUB-ASSEMBLY
Click here
4. REMOVE NO. 1 COOLING UNIT BRACKET
Click here
5. REMOVE NO. 2 COOLING UNIT BRACKET
Click here
6. REMOVE NO. 3 COOLING UNIT BRACKET
Click here
7. REMOVE COOLER UNIT CLAMP
Click here
8. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY
Click here
9. REMOVE NO. 2 AIR CONDITIONING HARNESS ASSEMBLY
(a) Disengage each clamp.
(b) Remove the 12 screws and rear cooling unit cover LH from the rear cooling unit cover RH. | |
(c) Disengage the 2 claws to remove the No. 2 air conditioning harness assembly. | |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Steering Gear: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during steering gear assembly removal/installation are shown below. Necessary Procedures After Parts Removed/I ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Lighting System (w/ Automatic Headlight Beam Level Control System): Abnormal Height Sensor Data at Initialization (B2452)
DESCRIPTION The No. 1 headlight ECU sub-assembly LH stores this DTC if the value from the rear height control sensor sub-assembly RH is out of range when performing initialization of the No. 1 headlight ECU sub-assembly LH, such as when the vehicle is not level or jacked up. for Multiple Beam Headli ...