REMOVAL
PROCEDURE
1. REMOVE MAP LIGHT ASSEMBLY
(a) Using a moulding remover, disengage the 4 clips and 2 guides. | |
(b) Disconnect each connector to remove the map light assembly.
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Panoramic Moon Roof System: Terminals Of Ecu
TERMINALS OF ECU CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY) (a) Disconnect the U2 sliding roof ECU (sliding roof drive gear assembly) connector. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure the values on the wire harness side with ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Front Evaporator Temperature Sensor: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front evaporator temperature sensor removal/installation are shown below. Necessary Procedure After Par ...