Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front power seat switch removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
*: When performing learning using the Techstream.
Click here | |||
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Lane Control System | |
| Pre-collision System | |||
| Intelligent Clearance Sonar System* | |||
| Parking Assist Monitor System | | ||
| Panoramic View Monitor System | | ||
| Lighting System (w/ Automatic Headlight Beam Level Control System) | | ||
| Initialize back door lock | Power Door Lock Control System | | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | | |
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY
Click here .gif)
2. DISCONNECT FRONT SEATBACK BOARD SUB-ASSEMBLY
Click here
3. REMOVE FRONT SEAT CUSHION SHIELD (for Standard Seat Type)
Click here
4. REMOVE INNER NO. 1 FRONT SEAT CUSHION SHIELD (for Sports Seat Type)
Click here
5. REMOVE FRONT SEAT CUSHION SHIELD (for Sports Seat Type)
Click here
6. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
Click here
7. REMOVE RECLINING POWER SEAT SWITCH KNOB
Click here
8. REMOVE FRONT POWER SEAT SWITCH
| (a) Remove the 3 screws and front power seat switch from the front seat cushion shield. |
|
Components
COMPONENTS ILLUSTRATION *A for Sports Seat Type - - *1 FRONT SEAT CUSHION SHIELD *2 INNER NO. 1 FRONT SEAT CUSHION SHIELD ILLUSTRATION *1 FRONT POWER SEAT SWITCH *2 FR ...
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT POWER SEAT SWITCH LH (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Slide Switch Tester Connection Conditi ...
Other materials:
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Rear Seat Reclining Control Cable: Installation
INSTALLATION PROCEDURE 1. INSTALL RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY RH (a) Engage the guide. (b) Install the 3 bolts. Torque: 18 N·m {184 kgf·cm, 13 ft·lbf} (c) Engage the 5 clamps to install the reclining remote control lever sub-assembly RH. 2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY R ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Front Camera System: Freeze Frame Data
FREEZE FRAME DATA DESCRIPTION (a) Whenever a front camera system DTC is stored, the forward recognition camera stores the current vehicle state (ECU and sensor information) as Freeze Frame Data. CHECK FREEZE FRAME DATA (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) T ...
Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual
- For your information
- Pictorial index
- For safety and security
- Instrument cluster
- Operation of each component
- Driving
- Lexus Display Audio system
- Interior features
- Maintenance and care
- When trouble arises
- Vehicle specifications
- For owners
Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual
0.0147