DESCRIPTION
HINT:
The rear door courtesy light switch is a collective term for the rear door courtesy light switch (for RH) and the rear door courtesy light switch (for LH).
The fold seat control ECU receives switch operation signals, the driving condition signal and rear door courtesy light switch assembly signal and operates the rear power seat according to these signals.
WIRING DIAGRAM
PROCEDURE
1. | INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY |
(a) Remove the rear door courtesy light switch assembly.
Click here
(b) Inspect the rear door courtesy light switch assembly.
Click here
NG | ![]() | REPLACE REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY |
|
2. | CHECK HARNESS AND CONNECTOR (FOLD SEAT CONTROL ECU - REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY) |
(a) for Rear RH Seat:
(1) Disconnect the x3 fold seat control ECU (rear RH seat) connector.
(2) Disconnect the R16 rear door courtesy light switch assembly (for RH) connector.
(b) for Rear LH Seat:
(1) Disconnect the y3 fold seat control ECU (rear LH seat) connector.
(2) Disconnect the S16 rear door courtesy light switch assembly (for LH) connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for Rear RH Seat
Tester Connection | Condition | Specified Condition |
---|---|---|
x3-18 (RCL) - R16-1 | Always | Below 1 Ω |
x3-18 (RCL) or R16-1 - Body ground | Always | 10 kΩ or higher |
for Rear LH Seat
Tester Connection | Condition | Specified Condition |
---|---|---|
y3-18 (RCL) - S16-1 | Always | Below 1 Ω |
y3-18 (RCL) or S16-1 - Body ground | Always | 10 kΩ or higher |
OK | ![]() | GO TO PROBLEM SYMPTOMS TABLE |
NG | ![]() | REPAIR OR REPLACE HARNESS OR CONNECTOR |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Ultrasonic Sensor (for Front): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ultrasonic sensor removal/installation are shown below. Necessary Procedure After Parts Removed/Install ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Rear No. 2 Seat Outer Belt Assembly: Inspection
INSPECTION PROCEDURE 1. INSPECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY RH (a) Before installing the rear No. 2 seat outer belt assembly RH, check the ELR function. NOTICE: Do not disassemble the retractor. (1) Hold the retractor at the angle it would be positioned when it is installed to the vehicle ...