COMPONENTS
ILLUSTRATION
*A | for RH Side | *B | for LH Side |
*1 | FRONT DECK SIDE TRIM COVER | *2 | REAR DOOR INSIDE SCUFF PLATE |
*3 | REAR DOOR SCUFF PLATE | *4 | REAR SEAT OUTER TRACK BRACKET COVER LH |
*5 | REAR SEAT OUTER TRACK BRACKET COVER RH | *6 | REAR SEAT SIDE GARNISH |
ILLUSTRATION
*A | for RH Side | *B | for LH Side |
*1 | COOLER (NO. 2 ROOM TEMP. SENSOR) THERMISTOR | *2 | DECK TRIM SIDE PANEL ASSEMBLY LH |
*3 | DECK TRIM SIDE PANEL ASSEMBLY RH | *4 | NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY |
*5 | NO. 1 LUGGAGE COMPARTMENT TRIM HOOK | *6 | NO. 2 AIR CONDITIONING CONTROL ASSEMBLY |
*7 | REAR NO. 2 SEAT OUTER BELT ASSEMBLY | *8 | ROOF SIDE INNER GARNISH ASSEMBLY |
*9 | ROPE HOOK ASSEMBLY | *10 | CLIP |
![]() | Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
ILLUSTRATION
*A | for RH Side | - | - |
*1 | REAR NO. 2 SIDE AIR DUCT | *2 | REAR NO. 6 AIR DUCT |
*3 | REAR NO. 7 AIR DUCT | - | - |
ILLUSTRATION
*1 | REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH | *2 | REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH |
*3 | OUTER BELT ANCHOR BRACKET SUB-ASSEMBLY LH | *4 | OUTER BELT ANCHOR BRACKET SUB-ASSEMBLY RH |
![]() | Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | ![]() | N*m (kgf*cm, ft.*lbf): Specified torque |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Vehicle Stability Control System: Left Front Wheel Speed Sensor Signal Stuck Low (C050023)
DESCRIPTION Refer to DTC C05001F. Click here DTC No. Detection Item DTC Detection Condition Trouble Area C050023 Left Front Wheel Speed Sensor Signal Stuck Low Any of the following is detected:
When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 10 km/h (6 mph ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Sliding Roof System: Operation Check
OPERATION CHECK CHECK AUTO OPERATION FUNCTION NOTICE:
Make sure that initialization has been completed before performing this inspection.
Click here
The sliding roof auto operation can be customized. Make sure that the auto operation customize setting is set to ON.
Click here HINT: When ...