Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual: Removal

Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual / Vehicle Interior / Seat Belt / Rear No. 1 Seat Outer Belt Assembly / Removal

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear No. 1 seat outer belt assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedures

Effect/Inoperative Function When Necessary Procedures are not Performed

Link

Disconnect cable from negative battery terminal

Memorize steering angle neutral point

Lane Control System

Pre-collision system

Intelligent clearance sonar system*1

Parking assist monitor system

Panoramic view monitor system

Lighting system (w/ Automatic Headlight Beam Level Control System)

Initialize back door lock

Power door lock control system

Reset back door close position

Power Back Door System (w/ Outside Door Control Switch)

*1: When performing learning using the Techstream.

Click here

CAUTION:

  • Be sure to read Precaution thoroughly before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

  • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
  • If an SRS part is accidentally deployed, it may cause a serious injury.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

3. REMOVE REAR NO. 2 SEAT ASSEMBLY

Click here

4. REMOVE REAR DOOR SCUFF PLATE

Click here

5. REMOVE REAR DOOR INSIDE SCUFF PLATE

Click here

6. REMOVE REAR SEAT OUTER TRACK BRACKET COVER LH (for LH Side)

for 60/40 Split Seat Type:

Click here

for Captain Seat Type:

Click here

7. REMOVE REAR SEAT OUTER TRACK BRACKET COVER RH (for RH Side)

for 60/40 Split Seat Type:

Click here

for Captain Seat Type:

HINT:

Use the same procedure as for the LH side.

Click here

8. REMOVE FRONT DECK SIDE TRIM COVER

Click here

9. REMOVE REAR SEAT SIDE GARNISH

Click here

10. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for LH Side)

Click here

11. REMOVE ROPE HOOK ASSEMBLY (for LH Side)

Click here

12. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for LH Side)

Click here

13. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for RH Side)

Click here

14. REMOVE ROPE HOOK ASSEMBLY (for RH Side)

HINT:

Use the same procedure as for the LH side.

15. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for RH Side)

Click here

16. REMOVE NO. 2 AIR CONDITIONING CONTROL ASSEMBLY (for LH Side)

Click here

17. REMOVE COOLER (NO. 2 ROOM TEMP. SENSOR) THERMISTOR (for LH Side)

Click here

18. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)

Click here

19. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)

Click here

20. DISCONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY

(a) Remove the bolt to disconnect the floor anchor of the rear No. 2 seat outer belt assembly.

(b) Disengage the 4 claws and 2 guides.

21. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY

Click here

22. REMOVE REAR NO. 2 SIDE AIR DUCT (for RH Side)

Click here

23. REMOVE REAR NO. 7 AIR DUCT (for RH Side)

Click here

24. REMOVE REAR NO. 6 AIR DUCT (for RH Side)

Click here

25. DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY

(a) Remove the bolt to disconnect the floor anchor of the rear No. 1 seat outer belt assembly.

26. REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH

(a) Remove the 4 bolts.

(b) Disengage the 2 guides.

(c) Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector.

HINT:

Tape the screwdriver tip before use.

*a

Locking Button

*b

Protective Tape

*c

Release

(d) Remove the nut.

(e) Disengage the 2 guides to remove the rear No. 1 seat outer belt assembly LH from the outer belt anchor bracket sub-assembly LH.

27. REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH

(a) Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector.

HINT:

Tape the screwdriver tip before use.

*a

Locking Button

*b

Protective Tape

*c

Release

(b) Remove the 4 bolts.

(c) Disengage the 2 guides.

(d) Remove the nut.

(e) Disengage the 2 guides to remove the rear No. 1 seat outer belt assembly RH from the outer belt anchor bracket sub-assembly RH.

    On-vehicle Inspection
    ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to correctly follow the removal and installation procedures for the rear No. 1 seat outer belt assembly. PROCEDURE 1. INSPECT REAR NO. 1 ...

    Inspection
    INSPECTION PROCEDURE 1. INSPECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY (a) Before installing the rear No. 1 seat outer belt assembly, check the ELR function. NOTICE: Do not disassemble the retractor. ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2024 Owners Manual > Adjusting the steering wheel and mirrors: Inside rear view mirror
    The rear view mirror's position can be adjusted to enable sufficient confirmation of the rear view. Adjusting the height of rear view mirror The height of the rear view mirror can be adjusted to suit your driving posture. Adjust the height of the rear view mirror by moving it up and down. ...

    Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Instrument Panel Speaker: Inspection
    INSPECTION PROCEDURE 1. INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (for 9 Speakers) (a) With the speaker installed, check that there is no looseness or other abnormalities. (b) Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities. (c) Measure the res ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2024 Copyright www.lexusrx.net
    0.0171