Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual: Removal

Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual / Vehicle Interior / Supplemental Restraint Systems / Rear Seat Side Airbag Assembly (w/ Rear No. 2 Seat) / Removal

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear seat airbag assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replacement Part or Procedure

Necessary Procedures

Effects / Inoperative when not performed

Link

Disconnect cable from negative battery terminal

Memorize steering angle neutral point

Lane control system

Pre-collision system

Intelligent clearance sonar system*1

Lighting system (w/ Automatic Headlight Beam Level Control System)

Parking assist monitor system

Panoramic view monitor system

Initialize back door lock

Power door lock control system

Reset back door close position

Power back door system

*1: When performing learning using the Techstream.

Click here

CAUTION:

  • Be sure to read Precaution thoroughly before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

NOTICE:

If a rear seat airbag assembly has been deployed, replace the rear seat airbag assembly, rear seatback frame sub-assembly, separate type rear seatback pad and separate type rear seatback cover with the necessary parts in accordance with the extent of the collision damage.

for LH Side: Click here

for RH Side: Click here

PROCEDURE

1. REMOVE REAR NO. 1 SEAT ASSEMBLY LH (for LH Side)

Click here

2. REMOVE REAR NO. 1 SEAT ASSEMBLY RH (for RH Side)

Click here

3. REMOVE REAR SEAT COVER CAP

Click here

4. REMOVE NO. 1 RECLINING ADJUSTER RELEASE HANDLE

Click here

5. REMOVE REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY (for LH Side)

Click here

6. REMOVE REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY (for RH Side)

Click here

7. REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD (for LH Side)

Click here

8. REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD (for RH Side)

Click here

9. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for RH Side)

Click here

10. REMOVE REAR SEATBACK COVER

Click here

11. REMOVE REAR SEATBACK BOARD CARPET ASSEMBLY

Click here

12. REMOVE SEAT BELT ANCHOR COVER CAP (for RH Side)

Click here

13. REMOVE REAR SEAT SHOULDER BELT COVER (for RH Side)

Click here

14. REMOVE REAR SEAT UPPER RECLINING COVER

Click here

15. REMOVE RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY

Click here

16. REMOVE SEPARATE TYPE REAR SEATBACK COVER WITH PAD (for LH Side)

Click here

17. REMOVE SEPARATE TYPE REAR SEATBACK COVER WITH PAD (for RH Side)

Click here

18. REMOVE RECLINING REMOTE CONTROL BEZEL

Click here

19. REMOVE REAR SEAT AIRBAG ASSEMBLY

CAUTION:

When storing the rear seat airbag assembly, keep the airbag deployment side facing upward.

Deployment Side

(a) Disconnect the rear seat airbag assembly connector.

*a

White Housing Lock

*b

Yellow CPA

Slide

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.

(1) Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)

(2) Push down the white housing lock again and disconnect the connector.

NOTICE:

Do not push down the part (A) shown in the illustration when disconnecting the connector.

(b) Disengage the 3 clamps.

(c) Disengage the 3 clamps and remove the 2 nuts and rear seat airbag assembly.

NOTICE:

  • Do not reuse the nuts.
  • Make sure that the rear seatback frame sub-assembly is not deformed. If it is deformed, replace it with a new one.
    On-vehicle Inspection
    ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to correctly follow the removal and installation procedures for the rear seat airbag assemblies. PROCEDURE 1. INSPECT REAR SEAT AIRBAG AS ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL REAR SEAT AIRBAG ASSEMBLY (a) Install the rear seat airbag assembly with 2 new nuts. Torque: 5.5 N·m {56 kgf·cm, 49 in·lbf} NOTICE: Do not reuse the nuts. Ma ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Intuitive Parking Assist System (w/ Intelligent Clearance Sonar System): Operation Check
    OPERATION CHECK Self-diagnosis System (a) When a malfunction occurs in the intuitive parking assist system or the system cannot be used, a warning is displayed on the multi-information display, each indicator blinks or is illuminated, and the meter buzzer sounds to inform the driver that the system ...

    Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Dynamic Torque Control Awd System: Parts Location
    PARTS LOCATION ILLUSTRATION *1 ECM *2 SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) *3 ELECTRO MAGNETIC CONTROL COUPLING SUB-ASSEMBLY - 4WD LINEAR SOLENOID *4 ENGINE ROOM RELAY BLOCK AND JUNCTION BLOCK ASSEMBLY - ECU-IG1 NO. 5 FUSE ILLUSTRATION *A w/o AVS *B w/ AVS ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2025 Copyright www.lexusrx.net
    0.0145