CUSTOMIZE PARAMETERS
CUSTOMIZE SMART ACCESS SYSTEM WITH PUSH-BUTTON START (for Start Function)
NOTICE:
HINT:
The following items can be customized.
(a) Customizing with the Techstream
(1) Connect the Techstream to the DLC3.
(2) Turn the engine switch on (IG).
(3) Turn the Techstream on.
(4) Enter the following menus: Customize Setting / Smart Key / Access or Warning.
(5) Select the setting by referring to the table below.
Smart Key / Access Tester Display | Description | Default | Setting | ECU |
---|---|---|---|---|
Ignition Available Area | Function that sets the area that the electrical key transmitter sub-assembly must be in before the engine switch can be operated. | All | 00:Front,01:All | Certification ECU (smart key ECU assembly) |
Engine Start Indicator | Function that turns the key indicator display on the multi-information display on or off. | ON | 0:OFF,1:ON | Certification ECU (smart key ECU assembly) |
Tester Display | Description | Default | Setting | ECU |
---|---|---|---|---|
Key Low Battery Warning | Function that enables or disables the sounding of the buzzer when the transmitter battery is low and the engine switch is turned off after being on (IG) for 20 minutes or more. | ON | 0:OFF,1:ON | Certification ECU (smart key ECU assembly) |
(b) Entry cancel function (manual operation)
HINT:
While the smart access system with push-button start is canceled, it is possible to lock and unlock the doors using the wireless operation, and the start system can be operated by holding the electrical key transmitter sub-assembly near the engine switch.
(1) The following functions are disabled when the smart access system with push-button start is canceled.
(2) When canceling the smart access system with push-button start through manual operation:
(3) Press the unlock switch of the electrical key transmitter sub-assembly.
(4) Open the driver door within 5 seconds of completing the previous step (driver door: closed → opened).
(5) With the driver door open, press the unlock switch of the electrical key transmitter sub-assembly 2 times within 5 seconds of completing the previous step.
NOTICE:
If the driver door is closed before or while pressing the unlock switch, the entry cancel setting mode will end.
(6) Perform the following procedure within 30 seconds of completing the previous step.
NOTICE:
If the driver door is closed before or while pressing the unlock switch, the entry cancel setting mode will end.
(7) Close the driver door within 5 seconds (driver door: open → closed).
(8) Check that the wireless buzzer sounds twice (short beeps) to confirm that the smart access system with push-button start has been canceled.
(9) Perform the following procedure to restore the smart access system with push-button start to the active state from the canceled state.
HINT:
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Audio And Visual System (for 8 Inch Display): Voice Recognition Microphone Disconnected (B1579)
DESCRIPTION The radio receiver assembly and telephone microphone assembly are connected to each other using the microphone connection detection signal lines. This DTC is stored when a microphone connection detection signal line is disconnected. DTC No. Detection Item DTC Detection Condition ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Sfi System: Catalyst System Efficiency Below Threshold Bank 1 (P042000,P043000)
MONITOR DESCRIPTION The ECM uses sensors mounted in front of and behind the Three-Way Catalytic Converter (TWC) to monitor its efficiency. The first sensor, the air fuel ratio sensor, sends pre-catalyst information to the ECM. The second sensor, the heated oxygen sensor, sends post-catalyst informat ...