REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
Click here
2. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
Click here
3. REMOVE REAR DOOR ARMREST COVER
Click here
4. REMOVE COURTESY LIGHT ASSEMBLY
Click here
5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
Click here
6. REMOVE REAR SPEAKER ASSEMBLY
NOTICE:
Do not touch the speaker cone.
(a) Disconnect the connector. | |
(b) Remove the 3 screws.
(c) Disengage the 2 guides to remove the rear speaker assembly. | |
7. REMOVE REAR NO. 2 SPEAKER ASSEMBLY
NOTICE:
Do not touch the speaker cone.
(a) Disconnect the connector. | |
(b) Remove the screw.
(c) Disengage the clip to remove the rear No. 2 speaker assembly.
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Power Mirror Control System (w/o Memory): Terminals Of Ecu
TERMINALS OF ECU CHECK OUTER MIRROR CONTROL ECU ASSEMBLY (DRIVER DOOR) (a) Disconnect the N4 outer mirror control ECU assembly (driver door) connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the con ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Sfi System: Cold Start Ignition Timing Performance (P050B00)
MONITOR DESCRIPTION This monitor will run when the engine is started at an engine coolant temperature of -10 to 50°C (14 to 122°F). The DTC is stored after the engine idles for 13 seconds (2 trip detection logic). The DTC is designed to monitor the ignition timing at cold start. When the engine is ...