INSTALLATION
PROCEDURE
1. INSTALL DCM (TELEMATICS TRANSCEIVER)
2. INSTALL NO. 4 TELEPHONE BRACKET
(a) Install the No. 4 telephone bracket with the screw.
3. INSTALL NO. 3 TELEPHONE BRACKET
(a) Install the No. 3 telephone bracket with the screw.
4. INSTALL DCM (TELEMATICS TRANSCEIVER) WITH BRACKET
(a) Install the DCM (telematics transceiver) with bracket with the 2 nuts.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
(b) Connect each connector.
5. INSTALL FRONT NO. 2 CONSOLE BOX INSERT
Click here
6. INSTALL CONSOLE BOX ASSEMBLY
Click here
7. DCM ACTIVATION
HINT:
After replacing the DCM (telematics transceiver), make sure to perform DCM activation.
Click here
8. PERFORM REGISTRATION
for Lexus Enform Remote Compatible Type:
HINT:
After replacing the DCM (telematics transceiver), make sure to perform code registration (immobiliser system).
Click here
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Front Drive Shaft Assembly: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL FRONT DRIVE SHAFT HOLE SNAP RING (for LH Side) (a) Install a new front drive shaft hole snap ring. NOTICE: Face the end gap of the f ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Steering Gear: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during steering gear assembly removal/installation are shown below. Necessary Procedures After Parts Removed/I ...