Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual: Precaution

NOTICE:

• After the engine switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
• When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the terminal is reconnected.

  System Name	See Procedure
  Lane Control System
  Pre-collision System
  Intelligent Clearance Sonar System
  Parking Assist Monitor System
  Panoramic View Monitor System
  Lighting System (w/ Automatic Headlight Beam Level Control System)
  Power Door Lock Control System
  Power Back Door System (w/ Outside Door Control Switch)

1. Move the vehicle to an open area with good GPS reception.

   HINT:

   The GPS icon is displayed on the map screen when the reception is good.

2. Turn the engine switch on (IG), and then wait several minutes while the system acquires time and location data and activates Destination Assist and Destination.

Lexus Enform System

...

Parts Location

PARTS LOCATION ILLUSTRATION *A w/ Navigation System - - *1 DCM (TELEMATICS TRANSCEIVER) *2 FRONT NO. 3 SPEAKER ASSEMBLY *3 DLC3 *4 RADIO RECEIVER ASSEMBLY *5 NAVIGA ...

Other materials:

Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Rear Seatback Heater (for 60/40 Split Seat Type Rh Side): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seatback heater removal/installation are shown below. Necessary Procedure After Parts Removed/Insta ...

Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Dynamic Torque Control Awd System: Data List / Active Test
DATA LIST / ACTIVE TEST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or states of switches, ...