CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. | VEHICLE BROUGHT TO WORKSHOP |
|
2. | CHECK THE CUSTOMER'S CONTRACT STATUS |
(a) Check if the satellite radio and LEXUS ENFORM contracts are valid, or if the contract period has ended using the vehicle inquiry function on TIS.
Result | Proceed to |
---|---|
Both Contracts are valid. | A |
Contract for satellite radio is not valid. | B |
Contract for LEXUS ENFORM is not valid. | C |
B | GO TO NAVIGATION SYSTEM |
C | GO TO SAFETY CONNECT SYSTEM |
|
3. | CHECK CAN COMMUNICATION SYSTEM* |
(a) Check if CAN communication system DTCs are output.
Click here
Result | Proceed to |
---|---|
CAN DTCs are not output. | A |
CAN DTCs are output. | B |
B | GO TO CAN COMMUNICATION SYSTEM |
|
4. | CHECK DTC* |
(a) Check for DTCs.
Safety connect system: Click here
Telematics system: Click here
Result | Proceed to |
---|---|
DTCs are not output. | A |
Safety connect system DTCs are output. | B |
Telematics system DTCs are output. | C |
B | GO TO SAFETY CONNECT SYSTEM |
C | GO TO TELEMATICS SYSTEM |
|
5. | PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table.
Click here
Result | Proceed to |
---|---|
Fault is not listed in Problem Symptoms Table. | A |
Fault is listed in Problem Symptoms Table. | B |
HINT:
If the symptom does not recur and no DTCs are output, perform the simulation method.
Click here
B | GO TO STEP 7 |
|
6. | PERFORM TROUBLESHOOTING* |
(a) Refer to Terminals of ECU.
Click here
|
7. | REPAIR OR REPLACE |
|
8. | CONFIRMATION TEST |
NEXT | END |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Front Radar Sensor System: Vehicle Control History
VEHICLE CONTROL HISTORY NOTICE: Make sure to record any output Vehicle Control History codes before clearing them and checking the Vehicle Control History again. CHECK VEHICLE CONTROL HISTORY (FRONT RADAR SENSOR SYSTEM) (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Wiper Switch: On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (a) Check the front washer operation. (1) Connect a voltmeter positive (+) lead to terminal J31-5 (WR) and a negative (-) lead to terminal J33-7 (WF). *a Component with harness connected (Windshield Wiper S ...