Use the overhead switches to open and close the moon roof and tilt it up and down.
Opening and closing
Press the switch again to fully open the moon roof.
*: Lightly press either side of the moon roof switch to stop the moon roof partway.
Tilting up and down
*: Lightly press either side of the moon roof switch to stop the moon roof partway.
■ The moon roof can be operated when The power switch is in ON mode.
■ Operating the moon roof after turning the hybrid system off The moon roof can be operated for approximately 45 seconds after the power switch is turned to ACCESSORY mode or turned off. It cannot, however, be operated once the driver's door is opened.
■ Jam protection function If an object is detected between the moon roof and the frame while the moon roof is closing or tilting down, travel is stopped and the moon roof opens slightly.
■ Sunshade The sunshade can be opened and closed manually. However, the sunshade will open automatically when the moon roof is opened.
■ Door lock linked moon roof operation
*: These settings must be customized at your Lexus dealer.
■ When the moon roof does not close normally Perform the following procedure:
1. Stop the vehicle.
2. Press and hold the "CLOSE" switch.*1 The moon roof will close, reopen and pause for approximately 10 seconds.*2 Then it will close again, tilt up and pause for approximately 1 second. Finally, it will tilt down, open and close.
3. Check to make sure that the moon roof is completely closed and then release the switch.
1. Stop the vehicle.
2. Press and hold the "UP" switch*1 until the moon roof moves into the tilt up position and stops.
3. Release the "UP" switch once and then press and hold the "UP" switch again.*1 The moon roof will pause for approximately 10 seconds in the tilt up position.*2 Then it will adjust slightly and pause for approximately 1 second. Finally, it will tilt down, open and close.
4. Check to make sure that the moon roof is completely closed and then release the switch.
*1: If the switch is released at the incorrect time, the procedure will have
to be performed
again from the beginning.
*2: If the switch is released after the above mentioned 10 second pause,
automatic
operation will be disabled. In that case, press and hold the "CLOSE" or "UP"
switch,
and the moon roof will tilt up and pause for approximately 1 second. Then it
will tilt
down, open and close. Check to make sure that the moon roof is completely closed
and then release the switch.
If the moon roof does not fully close even after performing the above procedure correctly, have the vehicle inspected by your Lexus dealer.
■ Alarm The alarm may be triggered if the alarm is set and the moon roof is closed using the door lock linked moon roof operation function.
■ Moon roof open warning buzzer The buzzer sounds and a message is shown on the multi-information display in the instrument cluster when the power switch is turned off and the driver's door is opened with the moon roof open.
■ Customization Some functions can be customized.
WARNING Observe the following precautions.
Failing to do so may cause death or serious injury.
■ Opening the moon roof
■ Opening and closing the moon roof
In order to prevent accidental operation, especially by a child, do not let a child operate the moon roof. It is possible for children and other passengers to have body parts caught in the moon roof.
■ Jam protection function
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Dynamic Torque Control Awd System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspect ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Wiper And Washer System: Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. System Name See Procedure Lane Control System Pre-collision Sys ...