Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual: Data List / Active Test

DATA LIST / ACTIVE TEST

DATA LIST

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

(a) Connect the Techstream to the DLC3.

(b) Start the engine.

(c) Turn the Techstream on.

(d) Enter the following menus: Chassis / Circumference Monitoring Camera Control Module / Data List.

(e) According to the display on the Techstream, read the Data List.

Chassis > Circumference Monitoring Camera Control Module > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

RHD/LHD Data Check

Verification of the RHD/LHD data

OK/NG

OK: Data verification normal

NG: Data verification abnormal

-

HV/ENG Data Check

Verification of the HV/ENG data

OK/NG

OK: Data verification normal

NG: Data verification abnormal

-

2WD/4WD Data Check

Verification of the 2WD/AWD data

OK/NG

OK: Data verification normal

NG: Data verification abnormal

-

Destination Data Check

Verification of the destination data

OK/NG

OK: Data verification normal

NG: Data verification abnormal

-

Main CPU Forced Termination Detection Record

A history item indicating that the main CPU did not enter standby status within 15 seconds of turning the engine switch off and a forced end was applied

Unrec/Rec

Unrec: Parking assist ECU is normal

Rec: Parking assist ECU is abnormal

-

Main CPU Abnormal Response Record

A history item indicating that the main CPU became unresponsive in normal status

Unrec/Rec

Unrec: Parking assist ECU is normal

Rec: Parking assist ECU is abnormal

-

Main CPU Abnormal Reset Record

A history item indicating that the main CPU was reset, although the engine switch was not turned off in normal status

Unrec/Rec

Unrec: Parking assist ECU is normal

Rec: Parking assist ECU is abnormal

-

Image Processing IC Written Protect Record

A history item indicating that the image processing IC memory was write protected

Unrec/Rec

Unrec: Parking assist ECU is normal

Rec: Parking assist ECU is abnormal

-

Image Processing IC Initialized Malfunction Record

A history item indicating that the image processing IC memory was not initialized

Unrec/Rec

Unrec: Parking assist ECU is normal

Rec: Parking assist ECU is abnormal

-

Main EEPROM Access Status

Main EEPROM access status

OK/NG

OK: Parking assist ECU is normal

NG: Parking assist ECU is abnormal

-

Sub EEPROM Access Status

Sub-EEPROM access status

OK/NG

OK: Parking assist ECU is normal

NG: Parking assist ECU is abnormal

-

System Power Supply Voltage Malfunction Record

A history item indicating an abnormally generated-voltage value from the system power source

Unrec/Rec

Unrec: Parking assist ECU is normal

Rec: Parking assist ECU is abnormal

-

Main CPU Starting Malfunction Record

A history item indicating that the main CPU did not start

Unrec/Rec

Unrec: Parking assist ECU is normal

Rec: Parking assist ECU is abnormal

-

CAN CPU Boot Malfunction Record

A history item indicating that the CPU controlling the input and output of the information obtained via the CAN communication system did not start and the information could not be retrieved

Unrec/Rec

Unrec: Parking assist ECU is normal

Rec: Parking assist ECU is abnormal

-

Visual Display Line Status

Displays the status of the video signals displayed on the multi-display

OK/NG

OK: GVIF cable is normal

NG: GVIF cable is abnormal

-

Wheel Speed Sensor (4wheel)

Reception state of the vehicle speed signal from the skid control ECU

OK/NG

OK: Speed signal received

NG: Speed signal not received

-

Continuous Bus Off

Continuous bus off status (Global)

Not Detected/Detected

Not detected: Communication condition available

Detected: Communication condition not available

-

Sending CAN Message

Communication condition from parking assist ECU (Global)

OK/NG

OK: Communication condition available

NG: Communication condition not available

-

Sending CAN Message (Local)

Communication condition from parking assist ECU (Local)

OK/NG

OK: Communication condition available

NG: Communication condition not available

-

Continuous Bus Off (Local)

Continuous bus off status (Global)

Not Detected/Detected

Not detected: Communication condition available

Detected: Communication condition not available

-

CAN Message Register Stuck (Local)

CAN message communication status (Local)

OFF/ON

OFF: CAN message communication is normal

ON: CAN message communication is abnormal

-

Shift R Position

Reverse signal

OFF/ON

OFF: Shift lever in any position except R

ON: Shift lever in R

-

Mirror Status

Outer rear view mirror position

Close/Open

Close: Outer rear view mirror in retracted position

Open: Outer rear view mirror in driving position

-

Camera Changing SW Signal Status

Signal status at the BLSW terminal (switch camera signal)

ON/OFF

ON: Panoramic view monitor switch on

OFF: Panoramic view monitor switch off

-

Back Camera Availability Consistency

Status of ECU stored in rear television camera assembly

OK/NG

OK: Normal

NG: Rear television camera assembly or parking Assist ECU is abnormal

-

Side Camera LH Availability Consistency

Status of ECU stored in side television camera assembly LH

OK/NG

OK: Normal

NG: Side television camera assembly LH or parking Assist ECU is abnormal

-

Front Camera Availability Consistency

Status of ECU stored in front television camera assembly

OK/NG

OK: Normal

NG: Front television camera assembly or parking Assist ECU is abnormal

-

Side Camera RH Availability Consistency

Status of ECU stored side television camera assembly RH

OK/NG

OK: Normal

NG: Side television camera assembly RH or parking Assist ECU is abnormal

-

Image Adjustment Status

Status of the image adjustment status

Incomplete/Processing/Complete

Incomplete: Image adjustment incomplete

Processing: Image adjustment in processing

Complete: Image adjustment completed

-

Number of DTC

Number of DTCs (past and present)

Min: 0, Max: 255

Number of DTCs will be displayed

-

    Dtc Check / Clear
    DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Chassis / Circumference Monitoring Ca ...

    ECU Malfunction (C1614)
    DESCRIPTION This DTC is stored if the parking assist ECU judges that there is an internal malfunction as a result of its self check. HINT: The parking assist ECU stores different types of information ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Panoramic View Monitor System: Side Camera Feedback Malfunction (C1683)
    DESCRIPTION This DTC is stored if the parking assist ECU judges as a result of its self check that a synchronization problem is occurring in the image signal sent from the passenger side television camera assembly to the parking assist ECU. DTC No. Detection Item DTC Detection Condition Tro ...

    Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Front Passenger Airbag Assembly: Disposal
    DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations. Pre-disposal deployment may be considered hazardous material treatment. PROCEDURE 1. PRECAUTION CAUTION: ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2024 Copyright www.lexusrx.net
    0.0151