COMPONENTS
ILLUSTRATION
*A | w/ AVS | *B | w/o AVS |
*1 | NO. 2 PARKING BRAKE WIRE ASSEMBLY | *2 | REAR FLEXIBLE HOSE |
*3 | REAR SPEED SENSOR | *4 | WIRE HARNESS |
![]() | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
*1 | REAR AXLE SHAFT NUT | *2 | REAR COIL SPRING |
*3 | REAR LOWER COIL SPRING INSULATOR | *4 | REAR NO. 1 SUSPENSION ARM ASSEMBLY |
*5 | REAR NO. 2 SUSPENSION ARM ASSEMBLY | *6 | REAR STABILIZER LINK ASSEMBLY |
*7 | REAR SUSPENSION ARM COVER | *8 | REAR UPPER CONTROL ARM ASSEMBLY |
*9 | REAR STABILIZER BAR | *10 | REAR SUSPENSION TOE ADJUST CAM SUB-ASSEMBLY |
*11 | REAR NO. 2 SUSPENSION CAMBER ADJUST CAM | *12 | REAR LOWER SUSPENSION MEMBER STOPPER |
*13 | SPACER | - | - |
![]() | N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with a ball joint lock nut wrench |
● | Non-reusable part | ![]() | Do not apply lubricants to the threaded parts |
ILLUSTRATION
*1 | REAR DRIVE SHAFT ASSEMBLY | *2 | REAR DRIVE SHAFT SNAP RING |
● | Non-reusable part | ![]() | Do not apply lubricants to the threaded parts |
![]() | Toyota genuine differential gear oil LT 75W-85 GL-5 or equivalent | - | - |
ILLUSTRATION
*A | for Type A | *B | for Type B |
*1 | REAR DRIVE SHAFT DUST COVER | *2 | REAR DRIVE SHAFT INBOARD JOINT ASSEMBLY |
*3 | REAR DRIVE SHAFT INBOARD JOINT BOOT | *4 | REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP |
*5 | REAR DRIVE SHAFT OUTBOARD JOINT BOOT | *6 | REAR DRIVE SHAFT OUTBOARD JOINT BOOT CLAMP |
*7 | REAR NO. 2 DRIVE SHAFT INBOARD JOINT BOOT CLAMP | *8 | REAR NO. 2 DRIVE SHAFT OUTBOARD JOINT BOOT CLAMP |
*9 | SHAFT SNAP RING | *10 | TRIPOD JOINT |
*11 | REAR DRIVE SHAFT OUTBOARD JOINT SHAFT ASSEMBLY | - | - |
● | Non-reusable part | - | - |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Side Turn Signal Light Assembly: Components
COMPONENTS ILLUSTRATION *1 NO. 1 OUTER MIRROR COVER *2 NO. 2 OUTER MIRROR COVER *3 OUTER MIRROR *4 OUTER MIRROR HOLE COVER *5 SIDE TURN SIGNAL LIGHT ASSEMBLY - - ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Fuel Sender Gauge Assembly: Inspection
INSPECTION PROCEDURE 1. INSPECT FUEL SENDER GAUGE ASSEMBLY (a) Check that the float moves smoothly between F and E. (b) Check the fuel sender gauge assembly voltage. (1) Apply 5 V between terminals 2 and 3. NOTICE:
Be careful when connecting the leads, as the fuel sender gauge assembly may b ...