Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual: Fail-safe Chart

• If a malfunction is detected in the 4WD ECU assembly, the 4WD ECU assembly may stop AWD control and transfer all torque to the front wheels, or function in a such a way as to prevent damage to the system.
• If a malfunction is detected in the sensor or actuator, current to the 4WD linear solenoid of the electro magnetic control coupling sub-assembly is cut. As a result, all torque is transferred to the front wheels.
• When a malfunction is detected in the AWD system, operations related to the malfunction will be prohibited. However, if the function is operating when the fail-safe function activates, the operation may be permitted to continue temporarily to prevent sudden changes in the vehicle condition.
• When the AWD system is malfunctioning, a warning message is displayed on the multi-information display to inform the driver.

Data List / Active Test

DATA LIST / ACTIVE TEST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faul ...

Linear Solenoid Power Supply System Malfunction (C120C)

DESCRIPTION This DTC is output by the 4WD ECU assembly if a malfunction occurs in the linear solenoid power supply system. DTC No. Detection Item DTC Detection Condition Trouble Area C120 ...

Other materials:

Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Front Drive Shaft Assembly: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL FRONT DRIVE SHAFT HOLE SNAP RING (for LH Side) (a) Install a new front drive shaft hole snap ring. NOTICE: Face the end gap of the f ...

Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Drive Belt: Installation
INSTALLATION PROCEDURE 1. INSTALL V-RIBBED BELT (a) Install the V-ribbed belt. NOTICE: Make sure to put the backside of the V-ribbed belt on the V-ribbed belt tensioner assembly pulley and No. 2 idler pulley sub-assembly. Check that the V-ribbed belt is properly set to each pulley. ...