INSTALLATION
PROCEDURE
1. INSTALL FUEL PUMP CONTROL ECU ASSEMBLY
(a) Install the fuel pump control ECU assembly to the vehicle body and return the deck trim side panel assembly LH to its original position.
(b) Install the 2 nuts.
Torque:
8.0 N·m {82 kgf·cm, 71 in·lbf}
(c) Install the clip.
(d) Connect the 2 fuel pump control ECU assembly connectors.
2. INSTALL FRONT DECK FLOOR BOX
Click here
3. INSTALL REAR NO. 4 FLOOR BOARD
Click here
4. INSTALL REAR DECK FLOOR BOX
Click here
5. INSTALL DECK BOARD ASSEMBLY
Click here
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Camshaft Oil Control Solenoid (for Bank 1): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during camshaft timing oil control solenoid assembly bolt removal/installation are shown below. Necessary Proce ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Rear Door Outside Moulding: Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedures for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY (a) Disengage the clip. (b) Using a moulding remover, disengage the 5 claws and tu ...