COMPONENTS
ILLUSTRATION
*1 | COURTESY LIGHT ASSEMBLY | *2 | REAR DOOR ARMREST COVER |
*3 | REAR DOOR INNER GLASS WEATHERSTRIP | *4 | REAR DOOR INSIDE HANDLE BEZEL PLUG |
*5 | REAR DOOR TRIM BOARD SUB-ASSEMBLY | *6 | REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL |
ILLUSTRATION
*1 | REAR DOOR GLASS RUN | *2 | REAR DOOR GLASS SUB-ASSEMBLY |
*3 | REAR DOOR NO. 2 TRIM BRACKET | *4 | REAR DOOR REAR GUIDE SEAL |
*5 | REAR DOOR SERVICE HOLE COVER | *6 | REAR DOOR WEATHERSTRIP |
*7 | REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY | *8 | HOLE PLUG |
![]() | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
*1 | REAR DOOR BELT MOULDING ASSEMBLY | - | - |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Steering Gear: Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE STEERING RACK BOOT CLIP (for LH Side) (a) Using pliers, remove the steering rack boot clip. 2. REMOVE STEERING RACK BOOT CLIP (for RH Side) HINT: Perform the same procedure as for the LH side. 3. REMOVE NO. 2 STEERING RACK BOOT CLAMP (for LH Side) (a) Using a screw ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Rear Seat Side Airbag Assembly (for Captain Seat Type): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear seat airbag assembly removal/installation are shown below. Necessary Procedure After Parts Remove ...