Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual: License Plate Light Assembly

Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual / Vehicle Exterior / Lighting (ext) / License Plate Light Assembly

Components

COMPONENTS

ILLUSTRATION

*1

LICENSE PLATE LIGHT ASSEMBLY

-

-

Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY

Click here

2. REMOVE LICENSE PLATE LIGHT ASSEMBLY

(a) Disconnect the connector.

(b) Disengage the 2 claws to remove the license plate light assembly.

Inspection

INSPECTION

PROCEDURE

1. INSPECT LICENSE PLATE LIGHT ASSEMBLY LH

(a) Apply battery voltage to the license plate light assembly LH and check that the light comes on.

OK:

Condition

Specified Condition

Battery positive (+) → Terminal 1 (B)

Battery negative (-) → Terminal 2 (E)

License plate light comes on

If the result is not as specified, replace the license plate light assembly LH.

*a

Component without harness connected

(License Plate Light Assembly LH)

2. INSPECT LICENSE PLATE LIGHT ASSEMBLY RH

(a) Apply battery voltage to the license plate light assembly RH and check that the light comes on.

OK:

Condition

Specified Condition

Battery positive (+) → Terminal 1 (B)

Battery negative (-) → Terminal 2 (E)

License plate light comes on

If the result is not as specified, replace the license plate light assembly RH.

*a

Component without harness connected

(License Plate Light Assembly RH)

Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. INSTALL LICENSE PLATE LIGHT ASSEMBLY

(a) Engage the 2 claws to install the license plate light assembly.

(b) Connect the connector.

2. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY

Click here

    High Mounted Stop Light Assembly
    ComponentsCOMPONENTS ILLUSTRATION *1 CENTER STOP LIGHT ASSEMBLY - - RemovalREMOVAL PROCEDURE 1. REMOVE REAR SPOILER SUB-ASSEMBLY Click here 2. REMOVE CENTER STOP LIGHT ASSEMBLY (a) App ...

    Lighting System (w/ Automatic Headlight Beam Level Control System)
    ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Air Fuel Ratio Sensor: Inspection
    INSPECTION PROCEDURE 1. INSPECT AIR FUEL RATIO SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 (HA1A) - 2 (+B) 1 (HA2A) - 2 (+B) 20°C (68°F) 1.6 to 3.2 Ω 1 (HA1A) - 4 (A1A ...

    Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Sliding Roof Housing (for Slidng Roof): Installation
    INSTALLATION PROCEDURE 1. INSTALL SLIDING ROOF HOUSING ASSEMBLY (a) Loosen the 10 bolts of the brackets of the sliding roof housing assembly. (b) Temporarily install the sliding roof housing assembly with the 6 nuts and 8 bolts. (c) Tighten the 2 nuts. HINT: Tighten the 2 nuts in the order shown in ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2024 Copyright www.lexusrx.net
    0.0128