REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during instrument panel box light removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
---|---|---|---|
*1: When performing learning using the Techstream.
Click here | |||
Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Lane Control System |
|
Pre-collision System | |||
Intelligent Clearance Sonar System*1 | |||
Lighting system (w/ Automatic Headlight Beam Level Control System) |
| ||
Parking assist monitor system |
| ||
Panoramic view monitor system |
| ||
Initialize back door lock | Power door lock control system |
| |
Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) |
|
PROCEDURE
1. REMOVE RADIO RECEIVER ASSEMBLY WITH REGISTER
Click here
2. REMOVE CONSOLE BOX ASSEMBLY
Click here
3. REMOVE NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY
(a) Disengage the 2 claws to remove the No. 1 interior illumination light assembly. | |
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Towing Converter Relay: Components
COMPONENTS ILLUSTRATION *1 DECK BOARD ASSEMBLY *2 DECK SIDE TRIM BOX RH *3 REAR DECK FLOOR BOX *4 REAR FLOOR FINISH PLATE *5 REAR NO. 3 FLOOR BOARD *6 REAR NO. 4 FLOOR BOARD *7 TONNEAU COVER ASSEMBLY - - ILLUSTRATION *A w/o Rear Power Seat System *B ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Can Communication System: Power Steering ECU Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Power Steering ECU Communication Stop Mode Either condition is met:
"Power Steering (EPS)" is not displayed on the CAN Bus Check screen of the Techstream.
Click here
Communication system DTCs (DTCs that start with U) that corresp ...