DIAGNOSIS SYSTEM
CHECK DLC3
(a) Check the DLC3.
Click here
FUNCTION OF PASSENGER AIRBAG ON/OFF INDICATOR
(a) Initial check
(1) Turn the engine switch on (IG).
(2) The passenger airbag ON/OFF indicator comes on for approximately 4 seconds, then goes off for approximately 2 seconds.
(3) Approximately 6 seconds after the engine switch is turned on (IG), the passenger airbag ON/OFF indicator will indicate ON/OFF depending on the following conditions.
Indicator Operation Front Passenger Seat Condition | Passenger Airbag ON/OFF Indicator | SRS Warning Light | |
---|---|---|---|
ON Indicator | OFF Indicator | ||
Vacant | OFF | ON | OFF |
Adult*1 is seated | ON | OFF | OFF |
Child*2 is seated | ON or OFF*2 | OFF or ON*2 | OFF |
Child restraint system is installed | OFF | ON | OFF |
Occupant classification system failure | OFF | ON | ON |
HINT:
PASSENGER AIRBAG ON/OFF INDICATOR CHECK
(a) Turn the engine switch on (IG).
*A | Type A |
*B | Type B |
(b) Check that the passenger airbag ON/OFF indicator ("ON" and "OFF") comes on for approximately 4 seconds, then goes off for approximately 2 seconds.
HINT:
Refer to the indicator operation table in Function of Passenger Airbag ON/OFF Indicator for the passenger airbag ON/OFF indicator operation when the engine switch is turned on (IG) and approximately 6 seconds elapse.
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Power Back Door Control Switch: Removal
REMOVAL PROCEDURE 1. REMOVE INSTRUMENT PANEL GARNISH LH Click here 2. REMOVE FRONT DOOR SCUFF PLATE LH w/o Rear No. 2 Seat: Click here w/ Rear No. 2 Seat: Click here 3. REMOVE COWL SIDE TRIM BOARD LH Click here 4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here 5. DI ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Lexus Enform System: DCM Data Signal Circuit between Navigation ECU and DCM
DESCRIPTION This circuit is used to send and receive signals between the DCM (Telematics Transceiver), radio receiver assembly and navigation ECU. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - DCM (TELEMATICS TRANSCEIVER)) (a) Disconnect the J157 DCM (T ...