DESCRIPTION
These DTCs are stored when a malfunction occurs in the radio receiver assembly
DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
---|---|---|---|
B1551 | HD Radio Tuner Malfunction | When any of the following conditions is met:
| Radio receiver assembly |
B15A0 | LAN Master Malfunction | When either of the following conditions is met:
| Radio receiver assembly |
B15B3 | Radio Tuner Malfunction | When either of the following conditions is met:
| Radio receiver assembly |
B15B4 | CD Changer Malfunction | When any of the following conditions is met:
| Radio receiver assembly |
B15B5 | DVD Changer Malfunction | When any of the following conditions is met:
| Radio receiver assembly |
B15B7 | Bluetooth Module Malfunction | "Bluetooth" module malfunction | Radio receiver assembly |
B15BA | XM Tuner Malfunction | When either of the following conditions is met:
| Radio receiver assembly |
B15F9 | UART Communication Malfunction(for A/C) | When either of the following conditions is met:
| Radio receiver assembly |
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here
PROCEDURE
1. | CHECK DTC |
(a) Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs(b) Recheck for DTCs and check that no DTCs are output.
Body Electrical > Navigation System > Trouble CodesOK:
No DTCs are output.
OK | USE SIMULATION METHOD TO CHECK |
NG | REPLACE RADIO RECEIVER ASSEMBLY |
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Rear No. 1 Seat Assembly (for 60/40 Split Seat Type Lh Side): Reassembly
REASSEMBLY CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the seat frame may injure your hands. PROCEDURE 1. INSTALL REAR SEATBACK FRAME SUB-ASSEMBLY LH (a) Temporarily install the rear seatback frame sub-assembly LH to the No. 1 seat cushion frame sub-assembly LH as shown i ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Steering Pad Switch: Installation
INSTALLATION PROCEDURE 1. INSTALL STEERING PAD SWITCH ASSEMBLY (a) Engage the 2 claws and 2 pins to install the steering pad switch assembly. (b) Install the 2 screws. Torque: 2.4 N·m {24 kgf·cm, 21 in·lbf} (c) Connect the steering pad switch connector to the spiral cable with sensor sub-assembl ...