CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here
PROCEDURE
1. | CHECK VEHICLE SIGNAL (OPERATION CHECK) |
(a) Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check. Click here |
|
(b) Check that the display changes between ON and OFF according to the light control switch operation.
OK:
Light Control Switch | Display |
---|---|
Tail or head | ON |
Off or AUTO | OFF |
HINT:
OK | ![]() | REPLACE RADIO RECEIVER ASSEMBLY |
NG | ![]() | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Radio Antenna Cord (w/ Rear No. 2 Seat): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during antenna cord sub-assembly removal/installation are shown below. Necessary Procedures After Parts Remove ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Panoramic View Monitor Switch: Removal
REMOVAL PROCEDURE 1. REMOVE INSTRUMENT PANEL GARNISH LH Click here 2. REMOVE FRONT DOOR SCUFF PLATE LH Click here 3. REMOVE COWL SIDE TRIM BOARD LH Click here 4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here 5. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY C ...