CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here
PROCEDURE
1. | CHECK DISC |
(a) Check that the disc is not deformed or cracked. OK: No deformation or cracks on the disc | |
NG | END (DISC IS FAULTY) |
|
2. | CHECK DISC |
(a) Check the disc. OK: The disc is clean. NOTICE: Do not use a conventional record cleaner or anti-static preservative. HINT: If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction. | |
NG | CLEAN DISC |
|
3. | REPLACE DISC AND RECHECK |
(a) Replace the disc with a new or known good one and check that the malfunction disappears.
OK:
Malfunction disappears.
OK | END (DISC WAS FAULTY) |
|
4. | CHECK RADIO RECEIVER ASSEMBLY |
(a) Check the radio receiver assembly installation condition.
(1) Check that the radio receiver assembly is properly installed.
OK:
The radio receiver assembly is properly installed.
OK | REPLACE RADIO RECEIVER ASSEMBLY |
NG | REINSTALL RADIO RECEIVER ASSEMBLY |
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Headup Display System: Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or states of ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Rear No. 1 Seat Outer Belt Assembly: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSPECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY Click here 2. INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH (a) Engage the 2 guides. (b) Inst ...