CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here
PROCEDURE
1. | START DIAGNOSTIC MODE |
(a) Activate diagnostic mode and check if the "Service Menu" screen can be displayed.
Click here
OK:
Diagnostic mode can be activated.
NG | GO TO STEP 3 |
|
2. | CHECK PANEL SWITCH (OPERATION CHECK) |
(a) Enter the "Panel&Steering Switch Check Mode" screen. Refer to Check Panel & Steering Switch in Operation Check. Click here | |
(b) Operate the abnormal switch and check if the switch status is correctly displayed.
OK:
The switch status is correctly displayed as operated.
OK | REPLACE RADIO RECEIVER ASSEMBLY |
NG | GO TO STEP 3 |
3. | REMOTE TOUCH (REMOTE OPERATION CONTROLLER ASSEMBLY) SELF CHECK (SWITCH OPERATION CHECK) |
(a) Enter self-diagnostic mode.
Click here
(b) Operate the remote touch screen in the upper left to turn the switch illumination off. NOTICE: Since the remote touch screen may recognize a pinch in/out or flick operation if operated with 2 fingers, always use 1 finger to operate the remote touch screen in self-diagnostic mode. |
|
(c) With the switch illumination turned off, press each switch of the remote touch (remote operation controller assembly) and check that the switch illumination turns on.
Result | Proceed to |
---|---|
Self check mode cannot be activated. | A |
Some switches do not turn on the switch illumination when they are pressed. | |
All switches turn on the switch illumination when they are pressed. | B |
A | REPLACE REMOTE TOUCH (REMOTE OPERATION CONTROLLER ASSEMBLY) |
B | REPLACE RADIO RECEIVER ASSEMBLY |
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Air Conditioning System: Rear Room Temperature Sensor Circuit (B1419/19)
DESCRIPTION The cooler (No. 2 room temp. sensor) thermistor is installed in the rear panel to detect the rear cabin temperature, which is used to control the air conditioning system. The resistance of the cooler (No. 2 room temp. sensor) thermistor changes in accordance with the rear cabin temperatu ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Camshaft Position Sensor: Installation
INSTALLATION PROCEDURE 1. INSTALL VVT SENSOR (for Exhaust Side of Bank 2) (a) Apply a light coat of engine oil to the O-ring of the VVT sensor. NOTICE: If reusing the VVT sensor, be sure to inspect the O-ring. (b) Apply adhesive to 2 or 3 threads at the end of the bolt. Adhesive: Toyota Genuine ...